Update AP configuration through Hivemanager NG sometimes makes the AP unstable.

  • 1
  • Question
  • Updated 1 year ago
I have been using AP230 devices. What i find sometime is that after having configure them, if new changes needed to be made, sometimes new pushes (either Delta or Complete) makes the AP unstable. I have cases were the WiFi port was going UP/DOWN every 10-20 seconds, and other APs also not giving IP to anything connected.
But if I reset the AP to factory defaults and push the configuration as new (Conplete update) then it works. I have update the ones I am testing to the Golden Firmware.  

Do you have any feedback of why this happens?
Photo of gerjimi

gerjimi

  • 17 Posts
  • 1 Reply Like

Posted 1 year ago

  • 1

There are no replies.