Too many neighbors?

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
We are having issues where our AP141s are losing CAPWAP. I noticed in neighbor details of the APs it lists maybe all the APs in hivemanager. Is that a problem? These are located between 7 different buildings. We can't seem to figure out why our APs are losing CAPWAP. It happened about a month ago as well, we downgraded the firmware to the AP141s to 6.4...we also notice when this issue happens our IP phones also have issues. We have an open ticket but I figure the community usually is helpful. Any suggestions on troubleshooting? 
Photo of zzzP

zzzP

  • 19 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of BJ

BJ, Champ

  • 374 Posts
  • 45 Reply Likes
It sounds like your may be running into bandwidth issues. How does it look? Are you implementing QoS? Is there any firewalling between locations?

Best,
BJ
Photo of zzzP

zzzP

  • 19 Posts
  • 0 Reply Likes
I did some troubleshooting today and talked with Aerohive support, its def. not a bandwidth issue. The CPUs are at 100%, trying to figure out why that's happening.