SNMP Setting for PRTG

  • 1
  • Question
  • Updated 11 months ago
I ́m using the Hive manager in Enterprise   6.6r3a.
Now I ́m trying to get inforamtion to our Network monitoring system which is PRTG.
I ́ve setup all snmp settings which I read are needed

Here I created a new traffic rule, because I was unable to enable SNMP on the default one. Save Button greyed out.
Than I tried first time to get an snmp connect before really try to read data out of it. But I always get an error: HOST-RESOURCES-MIB::hrSystemUptime.0 = No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003) ( 0 seconds )
ping no problem. I use snmp v2 with port 161 (but also tried port 161). Also with trying to use the mib file will not work.

Photo of Roberto Dollinger

Roberto Dollinger

  • 1 Post
  • 0 Reply Likes

Posted 11 months ago

  • 1

There are no replies.