How can I show one AP on more than one level of our map?

  • 1
  • Question
  • Updated 5 years ago
  • Answered
  • (Edited)
Our building has an open plan where there's no ceiling between our lower, main, and upper levels. It appears as though one access point located on the main level gives us all the coverage we need to reach all 3 levels, but I don't see a way to show our one AP on more than one level of our map. Is this possible?
Photo of Jake Harris

Jake Harris

  • 6 Posts
  • 0 Reply Likes

Posted 5 years ago

  • 1
Photo of Brian Powers

Brian Powers, Champ

  • 396 Posts
  • 92 Reply Likes
See this topic below,

http://community.aerohive.com/aerohiv...

If I understand correctly, you're asking a similar question. And I think the only type of APs that will show "through floor" coverage are simulated APs. And only then it is based on the "Floor Attenuation" set on the maps when they were created (or right clicking on the map link in the left pane and choosing Edit).
Photo of Jake Harris

Jake Harris

  • 6 Posts
  • 0 Reply Likes
Thanks! I ended up just adding a Planned AP at approximately the same spot on my other levels and taking that data with a grain of salt.