LLDP info not exposed for red0

  • 1
  • Idea
  • Updated 10 months ago
  • (Edited)
When viewing AP's on the Monitor or Configuration page in Hivemanager Classic (8.1r1), table columns can be displayed to show LLDP information for Eth0 or Eth1 interfaces (Eth0 LLDP Sys-Name, Eth0 LLDP Port #, etc)

When AP's are configured to use Eth0 and Eth1 with redundancy a new interface is created and uses "Red0".

There is no column available to expose LLDP information received on Red0 therefore LLDP information cannot be displayed in the GUI table.  Eth0 and/or Eth1 will only show a "-" in these columns when a redundant interface is used.

The data can only be exposed by CLI or by checking off the AP in the GUI table and then going to Utilities > LLDP/CDP > Show LLDP Neighbors.  This is not a quick easy way to see mass LLDP information like you can with Eth0 and Eth1 in the AP table.

Please allow exposure of LLDP information for the red0 interface when redundant interfaces is used.
Photo of Brian Lowrance

Brian Lowrance

  • 10 Posts
  • 0 Reply Likes

Posted 10 months ago

  • 1
Photo of Brian Lowrance

Brian Lowrance

  • 10 Posts
  • 0 Reply Likes
Submitted as feature request on case 00210468