How can I get the Topology Planning tool to show RSSI from the floor below?

  • 1
  • Question
  • Updated 5 years ago
  • Answered
I am using the topology planning tool in HM Online. I added a building, then added the top floor, then added the floor below by right-clicking Add Floor Below. I also adjusted the offsets so the floors should line up properly.

I've added an actual AP onto the lower floor. When I turn on the estimated RSSI, it shows up fine on the floor it is on. When I switch to the upper floor, there is no RSSI on the top floor. How can I get it to estimate RSSI for the upper floor?

Shawn
Photo of Shawn Rasmussen

Shawn Rasmussen

  • 33 Posts
  • 3 Reply Likes

Posted 5 years ago

  • 1
Photo of Abby S

Abby S, Employee

  • 94 Posts
  • 47 Reply Likes
Official Response
hi Shawn,
Our planner tool can simulate the coverage for RSSI coverage bleeding through floors, but calculating the actual coverage from a connected AP across floors is not yet supported. I recommend asking your sales team to open a feature request - it is an excellent idea!