How to show radio power

  • 1
  • Question
  • Updated 3 years ago
  • Answered
Does anybody know how to show radio power on the CLI? I've tried to find this command for a few days now to no avail.

Thanks.
Photo of Alex

Alex

  • 6 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of BJ

BJ, Champ

  • 374 Posts
  • 45 Reply Likes
try "show acsp."

Best,
BJ
Photo of Alex

Alex

  • 6 Posts
  • 0 Reply Likes
You got it BJ, that's exactly what I needed! I thought it would make sense to find it under 'show interface... '.

Thanks a lot.
Photo of J. Goodnough

J. Goodnough, Champ

  • 266 Posts
  • 32 Reply Likes
EIRP will show up under sh int wifi[0|1] as well.
Photo of Alex

Alex

  • 6 Posts
  • 0 Reply Likes
Hmmmm... that's interesting... when comparing those 2 commands, the numbers don't correlate very well.. add a third data point (Hive Managers's WebUI) and it's even more out of whack. See below:

AP#sh acs
Interface Channel select state  Channel  Power ctrl state      Tx power(dbm)
--------- --------------------- -------- --------------------- -------------
Wifi0     Disable(User disable) 11       Disable(User disable) 9
Wifi1     Disable(User disable) 44       Disable(User disable) 20

AP#sh int wifi0 | i EIR
Freq(Chan)=2462Mhz(11); EIRP power=18.27dBm; Diversity=disabled;

AP#sh int wifi1 | i EIR
Freq(Chan)=5220Mhz(44); EIRP power=31.52dBm; Diversity=disabled;




All three outputs are from the same AP, taken at the same time. 
(Edited)
Photo of J. Goodnough

J. Goodnough, Champ

  • 266 Posts
  • 32 Reply Likes
The difference between tx power and reported EIRP is expected, the difference between the AP and HMOL is not necessarily - is the HMOL audit showing that the AP is in sync?
Photo of Alex

Alex

  • 6 Posts
  • 0 Reply Likes
Yes, the HM and the AP are in sync. We're not using HMOL, but on-premise HM.