Help with setting up CVG as L2 VPN server

  • 1
  • Question
  • Updated 2 years ago
  • Answered
Is there any deployments guide?
I can't figure out how to set up a CVG to be a L2 VPN server and a AP121 as the client.
When I choose the CVG to be a Layer 2 gateway, I can't set IP to the eth0 interface, only mgt0.
If I set a static IP on the mgt0 interface, I can't reach it on the local subnet.
Photo of Erik Gunnarsson

Erik Gunnarsson

  • 38 Posts
  • 6 Reply Likes

Posted 5 years ago

  • 1
Photo of Greg Taylor

Greg Taylor

  • 4 Posts
  • 0 Reply Likes
Aerohive's response

"Eth0 is the wan and eth1 is the inside lan. Before you can add an IP address both of the interfaces need to be in wan mode, see below. Also the mgt interface you see there is strictly for tunnel traffic and will never be seen on the wire"
Photo of Erik Gunnarsson

Erik Gunnarsson

  • 38 Posts
  • 6 Reply Likes
Hi and thanks for the respons,
unfortinatly I can't find where to set the interfaces to wan mode.
Photo of Erik Gunnarsson

Erik Gunnarsson

  • 38 Posts
  • 6 Reply Likes
I managed to get it working after a new clean setup.
Photo of YMEsko

YMEsko

  • 11 Posts
  • 1 Reply Like
Hi Erik,
How did you manage to configure the eth0 and eth1 interface? We need this kind of setup to meet our security ISO standard. In the test set up I have Mgt0 connected to both the LAN and DMZ side. I need to seperate the LAN side on a different interface but I haven't found documentation on how to do so.
Photo of Mike Kouri

Mike Kouri, Official Rep

  • 1030 Posts
  • 271 Reply Likes
Thanks for letting us know you were able to figure it out, Erik!!