Filtering clients by channel

  • 1
  • Question
  • Updated 5 years ago
  • Answered
Hello, I'm running Hivemanager 6.1r1. I am attempting to filter active clients by WiFi channel. Within the help section of Hivemanager, it states: "To filter the display based on the radio channel that the client is using, enter the radio channels here. You can enter a single channel by number, a series of channels by a hyphenated range (for example, "2-7"), or multiple, non-contiguous channels and ranges separated by commas."

However, when I attempt to put in a range (such as 36-157 or 1-11), the filter menu does not allow special characters. It will not let me use a hyphen or comma either. Numbers only, and even then it's capped at only three numbers.

Am I perhaps doing something wrong?
Photo of Matthew Hinson

Matthew Hinson

  • 6 Posts
  • 0 Reply Likes

Posted 5 years ago

  • 1
Photo of Mike Kouri

Mike Kouri, Official Rep

  • 1030 Posts
  • 271 Reply Likes
Matthew,
Assuming you are talking about filtering under Monitor->Active Clients, no you are not doing anything wrong, that's an error in our documentation. Thanks for bringing it to our attention, I will get that remedied.
Photo of Mike Kouri

Mike Kouri, Official Rep

  • 1030 Posts
  • 271 Reply Likes
The context-sensitive help system for HiveOS 6.1 has been updated to correct this error.
Photo of Matthew Hinson

Matthew Hinson

  • 6 Posts
  • 0 Reply Likes
Thanks! Glad I was able to be of assistance. :)