Enable Etherchannel

  • 1
  • Question
  • Updated 2 years ago
Is there a way to bulk change the network configuration to Etherchannel? I have added it in the "Auto Provisioning" policies to cover the new devices, but I have several hundred APs that aren't configured correctly. I can SSH to the APs to add the commands, but that doesn't sync back to Hive Manager and it will try to set it back. I've also played with the CLI Supplement option, but that doesn't seem like the best option. If I select multiple APs and select Modify, there isn't an option to set the Ethernet interfaces to aggregate mode.

Any way to do this quicker than modifying each AP individually?

Thanks,
-Dan
interface eth0 bind agg0
interface eth1 bind agg0
Photo of Dan Mellem

Dan Mellem

  • 52 Posts
  • 1 Reply Like

Posted 2 years ago

  • 1
Photo of Eastman Rivai

Eastman Rivai, Official Rep

  • 146 Posts
  • 17 Reply Likes
Dan,

You may create a supplemental CLI containing the above commands. You need to do a complete update at first so the CLI is in sync with the HM. Subsequently you may do delta update.

You may need to enabled supplemental CLI first
Home>HM settings>enable supplemental CLI

You then create the CLI and apply it to all APs. When you select all the APs you will see the supplemental CLI option in the advance settings.

Eastman
Photo of Dan Mellem

Dan Mellem

  • 52 Posts
  • 1 Reply Like
I didn't want to do a supplemental CLI since that doesn't update the "Interface and Network Settings" section in the device. Is there any other way of changing this setting other than going to every single device?

Thanks,
-Dan