Correct VLAN configuration in AP330

  • 1
  • Question
  • Updated 3 years ago
  • (Edited)


I need to create 2 VLANs on the AP.
2 SSID with each VLAN. For example, VLAN 10 in the corp SSID and VLAN 20 in the SSID Guest.
The AP will be connected directly to the LAN port of Cyberoam UTM.
Cyberoam has set vlan 2. Both the LAN port.
DHCP will be configured for each VLAN in Cyberoam.
As it would have to be configured the AP?


Photo of Rodrigo

Rodrigo

  • 19 Posts
  • 4 Reply Likes

Posted 3 years ago

  • 1
Photo of Ruwan Indika

Ruwan Indika

  • 66 Posts
  • 22 Reply Likes
Hi Rodrigo,



Photo of Rodrigo

Rodrigo

  • 19 Posts
  • 4 Reply Likes
no need to configure another parameter?
Photo of Ruwan Indika

Ruwan Indika

  • 66 Posts
  • 22 Reply Likes
Hi Rodrigo,

Once you push this configuration to the AP, the SSID Corp will be bridged to VLAN 10 and SSID Guest will be bridged to VLAN 20. The AP is a layer 2 device, it will bridge SSID to VLANs. When a client connect and send broadcast DHCP discover message it will be forwarded to the VLAN and the DHCP server in Cyberoam UTM will respond to DHCP discover.
Photo of Rodrigo

Rodrigo

  • 19 Posts
  • 4 Reply Likes
OK thank you very much
Photo of Maurice van Zundert

Maurice van Zundert

  • 31 Posts
  • 1 Reply Like
Hi Rodrigo, in your text you mention that Cyberroam has set VLAN 2, but in your drawing it shows VLAN 1 as the administrative.
Or do you mean 2 as in "two"?

In case of VLAN 1 you can use the setting in the example of Ruwan.
Photo of Rodrigo

Rodrigo

  • 19 Posts
  • 4 Reply Likes
It has two VLANs configured.