configure ap330 at home using cli

  • 1
  • Question
  • Updated 2 years ago
hi,
iv got a ap330 with no support, hoping to use it at home to extend my wife signal.
I'm using a power line adaptor and want to plug eth0 into the power line and then configure the ap through cli to extend the wife around my house.

It has no license and I would rather configure this through console.

I can get a trial hmol to set this up and the re deploy every 30 days but as I previously said I would rather just configure this through cli so I don't have to keep re deploying.

any advice welcomed.

G
Photo of George Squire

George Squire

  • 4 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Crowdie

Crowdie, Champ

  • 972 Posts
  • 272 Reply Likes
You could configure the AP330 access point through the HMOL and then enter the CLI command no hivemanager.
Photo of George Squire

George Squire

  • 4 Posts
  • 0 Reply Likes

I resolved my problem now.

Deployed 30 day free HM trial and configured it from there instead.