Config Audit view in last step of config wizard.

  • 2
  • Idea
  • Updated 5 years ago
Whenever i change a config, clicking the exclamation mark icon on the monitor > all devices page always show's me the cli commands that are being sent out to the AP's.

This same icon is also showed at the last step of the wizard in the 'configuration' tab. It seems to be a hyperlink but sadly, nothing is happening when i click on the icon over there.

Is it possible to show the same pop-up when clicking on it in the wizard? Although i really like the wizard-style config, i do like to see what commands will be sent to the AP's :-)

Best regards,
Sjoerd de Jong, Lantech, The Netherlands
Photo of Sjoerd de Jong

Sjoerd de Jong, Employee

  • 97 Posts
  • 20 Reply Likes

Posted 5 years ago

  • 2
Photo of Mike Kouri

Mike Kouri, Official Rep

  • 1030 Posts
  • 271 Reply Likes
Sjoerd,
My sincere apologies for the delay in responding to this, several of us thought someone else had already replied to you.

Our fundamental assumption was that if you are using our wizard to set up a device then we will be pushing a fairly large number of commands to that device, too many to conveniently display in the pop-up. Also, we assumed that the person executing the wizard probably would not understand the commands themselves.

We will take your request under advisement for possible future enhancement.