BR200 RESET problem

  • 1
  • Question
  • Updated 4 years ago
  • Doesn't Need an Answer
my BR200 not working after reset. i can log in through console port. router not assigning any ip addresses. cant get initial log in page as well
Photo of byte zone

byte zone

  • 7 Posts
  • 1 Reply Like

Posted 4 years ago

  • 1
Photo of Mike Kouri

Mike Kouri, Official Rep

  • 1030 Posts
  • 271 Reply Likes
When you say "reset" do you mean factory-reset via the pinhole, power reset only, or something else? Does the device reconnect to your HiveManager? If so, have you tried pushing a full config to it?
Photo of byte zone

byte zone

  • 7 Posts
  • 1 Reply Like
dear Mike,
there is no hivemanager installed, factory reset through the command line. now its not connecting and the indicator LED was always RED.
Photo of BJ

BJ, Champ

  • 374 Posts
  • 45 Reply Likes
The white LED will only light when connected to a HiveManager via capwap.

Best,
BJ
Photo of byte zone

byte zone

  • 7 Posts
  • 1 Reply Like
i can  login through the console port. it shows all the default vlues.

mgt0 ip 192.168.85.1 dhcp enabled, 

if i connect my lap to any one of the Eth ports (ie Eth1) the light blinks but in the same time if we run the show interface command the port state is down only Mgt0 is UP.

and my lap doesn't gets the IP address. i tried to assign the same class ip manually to my lap still i am not able to ping the BR200