AP250 - The configuration of device has been rolled back when trying to Activate AP

  • 1
  • Question
  • Updated 12 months ago
Hi everyone,

I am trying to Upload and Activate the Configuration on an AP250 and I keep getting the following result - 'The configuration of device has been rolled back' 

Model AP250 - HiveOS 7.1r1.142326  
HiveManager: Enterprise   6.8r7a

Does anyone have any ideas how to fix this issue.

Any help will be really appreciated

Photo of Jim Boyle

Jim Boyle

  • 1 Post
  • 0 Reply Likes

Posted 12 months ago

  • 1
Photo of Gary Smith

Gary Smith, Official Rep

  • 298 Posts
  • 61 Reply Likes
Hi Jim,

Sounds like the AP is loosing connectivity to the HiveManager and is rolling back as a result.

Are you changing the Management VLAN of the AP?
Are you setting a static IP address which in in a VLAN available to the AP?

Photo of Crowdie

Crowdie, Champ

  • 960 Posts
  • 269 Reply Likes
You should also check that the MGT0 interface's native VLAN matches the switch port's one.  You can check the MGT0 interface's native VLAN in the network policy applied to the access point or by executing a show int mgt0 command on the access point via CLI.