AP230 do VLAN Probe shown not available

  • 1
  • Question
  • Updated 3 years ago
I setup two VLANs in APs 230 and an Aerohive switch. one is native vlan 1, another is VLAN 200 for guest.

When I do VLAN probe for switch, it show me the VLAN 1 and VLAN 200 available and match to correct network. But when I try to do same test for AP230, it show me VLAN 1 network available but VLAN 200 no network.

I check the port setup in switch it is correct show me it is 802.1Q and allowed VLAN 1 and VLAN 200.

Any ideas?

Photo of Bin Yu

Bin Yu

  • 24 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of Eastman Rivai

Eastman Rivai, Official Rep

  • 146 Posts
  • 17 Reply Likes
Bin Yu,

Could provide us the output of the following?
show interface <int connected to the AP> switchport
show vlan id 200
show run | in vlan
show int mgt0
show user-profile

Thank you