AP141 - Autochannel switching still working even if it's disabled

  • 1
  • Question
  • Updated 10 months ago
I have 11 AP141 latest version as today, I've disabled the auto channel switching via HiveManager (cloud). Deployed and rebooted. All access points still change theirselves channel and not using the one I've setup in the single AP configuration. Is it possible to disable che autochannel switching via CLI?
Photo of Giorgio Marziani

Giorgio Marziani

  • 6 Posts
  • 0 Reply Likes

Posted 10 months ago

  • 1
Photo of Nick Lowe

Nick Lowe, Official Rep

  • 2491 Posts
  • 451 Reply Likes
Hi Giorgio,

There's no data here so difficult to give a definitive answer, but, based on previous cases, is this only at 5 GHz where DFS channels are in use?

Regards,

Nick
Photo of Giorgio Marziani

Giorgio Marziani

  • 6 Posts
  • 0 Reply Likes
Hi, yes, it happens on 5Ghz DFS channels. Does it enforced by DFS?
Photo of Nick Lowe

Nick Lowe, Official Rep

  • 2491 Posts
  • 451 Reply Likes
Hi Giorgio,

Yes, I suspect you would need to disable DFS if you want to not observe this on the AP141s in HiveOS 6.5rX. This is likely occurring due to DFS hits.

Regards,

Nick