AP 130 captive web portal - The interface must be in bridge-access mode....

  • 1
  • Question
  • Updated 12 months ago
Every time that I try to configure the Captive web portal on an AP 130 I get this error:
To assign a captive web portal to an Ethernet interface, the interface must be in bridge-access mode. Either change the operation mode of the Ethernet interface to bridge-access or remove the captive web portal assignment from it.
I only see one interface which is in Backhaul mode. Eth0

AH-161bc0#show interface

What am I doing wrong?☺
Photo of Eliu Rodriguez

Eliu Rodriguez

  • 16 Posts
  • 0 Reply Likes

Posted 12 months ago

  • 1
Photo of Eastman Rivai

Eastman Rivai, Official Rep

  • 146 Posts
  • 17 Reply Likes

Are you trying to configure captive web portal on the ethernet port for wired devices? This will require the eth0 port to be on the bridge mode. You would only do this if you want to connect wired devices to the AP.  You would configure this on AP130 if this AP has a mesh connection to another AP.   Could you please elaborate more on what you want to achieve?

If you want to enable CWP for wireless clients, this it not the correct way to do it.  You will need to configure it on the SSID section.