Accurate Maps Layout with Different Ceiling Heights

  • 1
  • Question
  • Updated 3 years ago
We have an industrial building with a ceiling height of about 30'.  It is wrapped on 2 sides with 2 story office space, each floor being about 15' ceiling height.  Entire space is covered by APs.  I'm just trying to figure out a strategy for putting this into HiveManager Maps section.  It looks like each floor in HM Maps can have only one designated ceiling height (AP installation height).  First floor consists of 15' and 30' ceiling heights.  If I average it, then the results will not be very accurate.  Just wondering if anyone has successfully configured this type of space in HM Maps.

Thanks,
Chris
Photo of Chris Glos

Chris Glos

  • 2 Posts
  • 0 Reply Likes

Posted 3 years ago

  • 1
Photo of BJ

BJ, Champ

  • 374 Posts
  • 45 Reply Likes
You would need to create two different maps. One possible issue that would arise, however would be if you use maps for classification. 

Best,
BJ
Photo of Chris Glos

Chris Glos

  • 2 Posts
  • 0 Reply Likes
Thanks BJ.  How do I deal with signal overlap on adjacent maps.  Is there a way to specify that the two maps are side by side vs vertical?  We routinely have systems in the offices connecting to AP;s in the plant and visa versa.